Lookah - Python Wax Vape Pen (Red)

How to Use the Lookah Python Dab Pen? Step 1: Make sure the battery of lookah python dab pen is fully charged before use. Open the flip lid and Use the dab tool to Place a small glob of wax onto the center of the atomizer plate. Do not overload the vape, as this can lead to a burnt taste and excess wax and can clog the vape. Step 2: Click the power button five times to turn the Python Wax vape on. When you turn the vape on, the display screen will flash three times, and then a countdown will start from 9 to 0. This indicates the atomizer is preheating. Step 3: Two clicks of the power button will change the voltage setting. There are total three voltage settings: Mode 1, Mode 2, Mode 3. These are shown by the numbers 1,2 or 3 on the digital screen. Mode 1: 3.4V Mode 2: 3.7V Mode 3: 4.0V Step 4: Swivile the mouthpiece to the open positions. Facing towards the power button. Press and hold the power button and, at the same time, inhale from the mouthpiece to vape for up to 10 seconds at a time. After 10 seconds, the display will flash 3 times, and the vape will return to standby. Step 5: When not in use, Turn off the Python Wax Pen by click the power button five times. And return the mouthpiece to the closed position. If you forget to do this, don't worry. If there is no operation for 60 minutes, the vape will automatically turn off. How to Clean the Lookah Python Dab Pen? After using the vape, Wipe around the inside of the coil with a Q-tip. This will clean away any excess wax and help keep the device clean. Remove the atomizer coil. Use a small brush or pipe cleaner and some isopropyl alcohol to clean around the threaded area of the vape and the airway passage in the vape. Clean the threaded end of the atomizer coil to remove any wax residue. Clean the mouthpiece with a small brush or pipe cleaner. Wipe around the inside of the lid with a Q-tip. You can use a damp cloth to wipe around the outside of the vape. Pro Tips: Maintaining your vape and coil will help you get the best from this device. You will get a better, richer vapor. How to Charge the Lookah Python Dab Pen? 1. Connect one end of a USB Type C cable to the vape and the other end to a USB charging port. 2. The screen will flash while the device is charging. 3. When fully charged, all seven (7) battery segments will show around the display, and the number 8 will show.